A perfect start if you want to get into tiny fabrication!
Scribe a reference point from the old pahnard tabs location.
Trim the plastic from the fender-well as needed for the new panhard mount.
Bold the panhard mount parts together with the rod end. I like to use Vanquish brass rod end because they are slightly wider than most. They work well for a spacing tool.
Clean the chassis opposite of your reference point so you can see your mark. Line up the panhard mount to the inside edge in this case.
Cover or remove any crucial components. I like to use old mig welding gloves for this.
Make a small tac on the prepped area part. Loosen the screw holding the spacer to swing the opposite piece out of the way. Weld the inside edge.
Clean the chassis opposite mounting front piece. Swing the rear mounting piece up to hte chassis weld.
Clean, paint and reassemble.
Installation video with helpfull notes .
Baja Bug Build
Get 15% off everything by typing in the code during checkout